Inversion liners and pull-In liners are made of a fibreglass/needle felt composite material in combination with a tubular foil

SOLTA®LINER FIBREGLASS containing a high, calibrated fibreglass component in combination with reliable needle felt, offer the right solution owing to their high load-bearing capacity and rugged line strength.


SOLTA®LINER FIBREGLASS therefore lends themselves superbly to deployment in waste-water conduits and pressure-pipes.

  • fibreglass / needle felt hose systems in single- and multi-layer construction
  • fibreglass content calibrated for high load-bearing capacity and pipe static
  • adaptive coating system for curing with hot water, steam or UV light
  • for the rehabilitation of waste-water conduits and pressure pipelines
  • adapted to diverse site conditions
  • suitable for several standard resin treatments (user verification is needed)
  • simple receptive to impregnants and very convenient installation



FIBERGLASS construction


diameters from DN 100 to DN 2000
wall thicknesses in stepped increments from 4 mm in to 30 mm
coating upon request
process PULL IN and inversion of the calibration hose
curing method hot water, steam or UV light
products which deviate from the standard are available upon request
FIBREGLASS liner after installation
FIBREGLASS liner after installation
back|Recommend this page   this page